FAQ - Electrical
- I have balanced outputs - XLR or 1/4" TRS Stereo Jack - on my equipment so how do I connect them?
- I have unbalanced outputs - RCA or 1/4" Mono Jack - on my equipment so how do I connect them?
- I have a stereo unbalanced output - 1/4" TRS Stereo Jack - on my equipment so how do I connect it to my monitors?
- How do I connect more than one monitor to a single output?
- I have no pre-amp outputs on my equipment - how do I connect the monitors to the speaker outputs of my power amplifier?
- What sort of cable should I use for digital connections?
- Which models in the GENELEC range are magnetically shielded?
- How do I control the volume of GENELEC monitors?
- How does the input sensitivity work on GENELEC monitors?
- What does the overload protection circuitry do, how does it work?
- Are GENELEC monitors damaged when the red light flashes or is on for a long period?
- Do I need to leave space behind the monitor for cooling?
- How to connect the 7050A subwoofer to my 8030A's / 8130A's?
- Can I use the 7050A or 1091A with 1030A's or with other GENELEC models?
- How long can my loudspeakers be on without powering them off?
- Could I connect two sources to the 5040A at the same time, using one at a time?
- Is it normal that my monitor red LED first light up for few seconds during power on?