Genelec 1022A
System Specifications
| Lower cut-off frequency, -3 dB: | 38 Hz | |
| Upper cut-off frequency, -3 dB: | 20 kHz | |
| Passband response tolerance, free field | ± 2 dB | |
| Maximum continuous sine wave acoustic output @ 1m on axis in free field | > 108 dB | |
| Maximum peak acoustic output per pair behind a console, 1.7 m from the engineer | > 121 dB | |
| -9 dBu will produce 102 dB SPL in free field @ 1 m on axis with the controls at 'CAL' position | ||
| Self generated noise level in free field @ 1m on axis | < 15 dB (A) | |
| Harmonic distortion at 98 dB SPL @ 1m on axis f < 200 Hz f > 200 Hz |
< 3 % < 1 % |
|
| Horizontal treble radiation loss at 30 deg off axis f = 10 kHz f = 15 kHz |
< 3 dB < 3 dB |
|
| Drivers Bass Mid Treble |
300 mm cone 80 mm cone 9 x 65 mm ribbon |
|
| Weight | 25 kg | |
| Dimensions: Height Width Depth |
735 mm 405 mm 365 mm |
|
Amplifier |
||
| Input connector | XLR female | |
| Bass amplifier output power: continuous transients |
150 W 190 W |
|
| Middle amplifier output power: continuous transients |
32 W 150 W |
|
| Treble amplifier output power: continuous transients |
7 W 150 W |
|
| Amplifier system distortion at nominal output THD SMPTE-IM CCIF-IM DIM100 |
< 0,05 % < 0,05 % < 0,05 % < 0,05 % |
|
| Mains voltage, specifications applicable operation |
220 VAC 198...242 VAC |
|
| Other mains voltage specifications available on request | ||
| Power consumption, idle full output |
30 VA 400 VA |
|
Crossover |
||
| Input impedance | 10 kOhm balanced | |
| Input level for maximum output, continuosly variable | -3...+16 dBu | |
| Subsonic attenuation | 12 dB @ 15 Hz | |
| Ultrasonic attenuation | 3 dB @ 30 kHz | |
| Crossover frequency bass / midrange midrange / treble |
400 Hz 3.8 kHz |
|
| Tone control operation range in 1 dB steps bass middle treble |
0...-6 dB 0...-6 dB 0...-6 dB |
|
| Bass roll-off filter, 2 dB steps | ||
All data subject to change without prior notice |
||