Genelec 1019A
System Specifications
| Lower cut-off frequency, -3 dB: | < 60 Hz | |
| Upper cut-off frequency, -3 dB: | > 20 kHz | |
| Free field frequency response tolerance of system | ± 3 dB | |
| Maximum continuous sine wave acoustic output @ 1m on axis in half space, averaged from 100 Hz to 2 kHz | > 100 dB SPL | |
| Maximum continuous RMS acoustic output in same conditions with IEC-weighted noise: | > 100 dB SPL | |
| Maximum peak acoustic output per pair on top of a console, 1 m from the engineer, with music material | > 115 dB | |
| A -20 dBu signal input will produce 88 dB SPL in a free field @1 m on axis with all controls set at the 'CAL' position. The CAL position is the 0 dB position of all tone controls and the maximum sensitivity position of the input level control. See specification in the Crossover Section | ||
| Self generated noise level in free field @ 1m on axis | < 10 dB | |
| Harmonic distortion at 85 dB SPL @ 1m on axis f < 300 Hz f > 300 Hz |
< 3 % < 1 % |
|
| Drivers Bass Treble |
5" cone (125 mm) 13/16" soft dome (21 mm) |
|
| Weight | 14.3 lb (6.5 kg) | |
| Dimensions: Height Width Depth |
12" (305 mm) 8 7/8" (225 mm) 9 5/8"(245 mm) |
|
Amplifier |
||
| Bass amplifier output power at 4 ohm load: continuous momentary |
22 W 35 W |
|
| Treble amplifier output power at 8 ohm load: continuous momentary |
6 W 20 W |
|
| Treble channel continuous output power is limited by the electronic overload protection | ||
| Slew rate | 10 V /µs | |
| Amplifier system distortion at nominal output THD SMPTE-IM CCIF-IM DIM100 |
< 0,2 % < 0,2 % < 0,2 % < 0,2 % |
|
| Signal to Noise ratio, from shorted system input to channel output, referred to full output: bass treble |
83 dB 87 dB |
|
| Mains voltage | 110/220/240 VAC | |
| Voltage operation Range | ± 10 % | |
| Power consumption, idle full output |
5 VA 50 VA |
|
Crossover |
||
| Input connector: XLR female | pin 2 + pin 3 - |
|
| To feed from unbalanced output connect pin 3 to pin 1 (ground) in the cable connector | ||
| Input impedance | 10 k balanced | |
| Continuously variable input level for maximum output | ||
| Subsonic filter | down 12 dB @ 25 Hz re 100 Hz level |
|
| Ultrasonic filter | down 12 dB @ 50 kHz re 10 kHz level |
|
| Crossover frequency | 3.5 kHz | |
| Crossover acoustical slopes | > 24 dB / octave | |
| Tone control operation range in 2 dB steps bass treble |
from 0 dB to - 8 dB from + 4 dB to - 4 dB |
|
| The 'CAL' position is 0 dB, the treble control slot set at vertical position and bass at 1 o'clock | ||
All data subject to change without prior notice |
||